PassMyTest

CDL Doubles and Triples Practice Test

Practice for the T endorsement: rollover risk, converter dollies, coupling and uncoupling twin trailers, air shut-off valves and safe driving with long combinations.

Loading your test…

About the T endorsement

The doubles/triples (T) endorsement lets you pull double and triple trailers with a Class A CDL. The knowledge test usually has 20 questions and requires 80%. Triple trailers are allowed only in some states and only on certain roads.

What the test covers

All 22 questions and answers

Take the test first, then open the list to review every question with its answer.

Show all 22 questions and answers
  1. In a set of doubles or triples, which trailer is most likely to turn over?Answer: The rear trailerBecause of the crack-the-whip effect (rearward amplification), the last trailer swings the most and is the most likely to roll over.
  2. To prevent rollovers with doubles and triples, you should:Answer: Steer gently and slow down for corners, ramps and curvesDoubles and triples are more likely to roll over than other combination vehicles. Steer gently and go slowly around corners, on-ramps and off-ramps.
  3. When building a set of doubles, where should the heavier trailer go?Answer: In the first position, right behind the tractorThe heavier trailer belongs in the first position and the lighter trailer at the rear. This reduces handling and rollover problems.
  4. What is a converter dolly?Answer: A coupling device with one or two axles and a fifth wheel that connects a semitrailer to the rear of a tractor-trailerThe converter dolly lets a semitrailer be pulled behind another trailer, forming a double.
  5. If the second (rear) trailer has no spring brakes, how can you secure it before coupling?Answer: Connect the emergency line, charge the trailer air tank, then disconnect the emergency lineThis sets the trailer emergency brakes, if the slack adjusters are adjusted correctly. Chock the wheels if you have any doubt.
  6. Where should the air shut-off valves (cut-out cocks) be closed in a set of doubles?Answer: At the rear of the last trailerThe shut-offs at the rear of the first trailer must be open so air reaches the next trailer. Only the valves at the rear of the last trailer are closed.
  7. Before driving doubles, the air shut-off valves at the rear of the first trailer should be:Answer: OpenThey must be open so air can flow to the second trailer. If they are closed, the rear trailer will not have working service brakes.
  8. How can you check that air reaches all the trailers?Answer: Open the emergency line shut-off at the rear of the last trailer and listen for air escapingWith the system charged, air escaping at the back of the last trailer shows the whole system is charged. Close the valve, then check the service line the same way while someone applies the brakes.
  9. Why should you never unlock the pintle hook while the dolly is still under the rear trailer?Answer: The dolly tow bar may fly up and injure someoneUnlocking the pintle hook with the dolly still under the trailer can make the tow bar fly up. Pull the dolly out from under the trailer first.
  10. Before pushing the converter dolly under the second trailer, the trailer should be:Answer: Slightly lower than the center of the fifth wheel, so it is raised slightly as the dolly goes underJust like coupling to a tractor, the trailer should be lifted slightly as the dolly fifth wheel slides under it.
  11. When uncoupling a set of doubles, which trailer do you uncouple first?Answer: The rear trailerUncouple the rear trailer first: park in a straight line, secure the trailer, lower its landing gear, close the shut-offs at the rear of the first trailer, disconnect the dolly lines and release the dolly fifth wheel latch.
  12. Compared with a single trailer, doubles and triples need:Answer: More following distance and more room to stop and maneuverDoubles and triples are long and cannot be turned or stopped suddenly. Look far ahead and keep extra space around the vehicle.
  13. On slippery roads, doubles and triples are:Answer: More likely to skid and jackknife, so you must slow downUse extra caution in bad weather. Drive slower and smoother than you would with a single trailer.
  14. The converter dolly connects to the rear of the first trailer with:Answer: A pintle hookThe dolly tow bar eye attaches to the pintle hook at the back of the first trailer. Then the air and electrical lines are connected.
  15. How do you release the brakes on a converter dolly that has no spring brakes?Answer: Open the dolly air tank petcock (drain valve)Opening the air tank petcock releases the dolly brakes so you can move it. Close it again before driving.
  16. Before driving, the converter dolly air tank drain valve should be:Answer: ClosedAn open drain valve lets air escape. Check that the drain is closed, the pintle hook is latched, safety chains are secured and the lines are connected and supported.
  17. To position a converter dolly in front of the second trailer, you should:Answer: Release the dolly brakes and line it up with the trailer kingpinRelease the dolly brakes, move the dolly into position in line with the kingpin of the second trailer, then back the first trailer into position and hook up the dolly.
  18. During the walkaround of a set of doubles, you should check that:Answer: The light cord is firmly plugged in and the lights work on every trailerCheck electrical cords, lights, air lines and glad hands on every trailer, and make sure all landing gear is fully raised.
  19. After coupling the dolly to the second trailer, you should:Answer: Check that the fifth wheel jaws are locked and do a gentle tug testCheck visually that the jaws are closed around the kingpin shank and pull gently against the locked trailer to make sure the coupling is secure.
  20. In an emergency stop with doubles that do not have antilock brakes, you should use:Answer: Controlled or stab brakingLocked wheels can make trailers skid and jackknife. Brake firmly without locking the wheels, or use stab braking.
  21. Which CDL endorsement is required to pull double or triple trailers?Answer: T (Doubles/Triples)The T endorsement is required for doubles and triples. Triple trailers are only allowed in some states.
  22. After coupling a set of doubles, the dolly support and trailer landing gear should be:Answer: Fully raised and securedRaise the second trailer’s landing gear fully and secure the dolly support in its raised position before driving.

Frequently asked questions

Are triple trailers legal in every state?

No. Triples are allowed only in some states, mostly in the West and Midwest, and only on certain roads. The T endorsement covers both doubles and triples.