Air brake numbers to know
| Governor cut-out | About 125 psi |
|---|---|
| Governor cut-in | About 100 psi |
| Low-pressure warning | Before pressure falls below 60 psi |
| Spring brakes apply | Between 20 and 45 psi |
| Safety relief valve | About 150 psi |
| Build-up (dual system) | 85 to 100 psi within 45 seconds |
| Static leakage (brakes released) | Under 2 psi/min single, 3 psi/min combination |
| Applied leakage | Under 3 psi/min single, 4 psi/min combination |
If you skip or fail the air brakes test, your CDL will carry a restriction that keeps you from driving commercial vehicles with full air brakes.
All 25 questions and answers
Show all 25 air brakes questions and answers
- Air brake systems are made up of three braking systems. They are:Answer: Service, parking and emergency brakesThe service brake slows and stops you, the parking brake holds the vehicle, and the emergency system stops you if the service system fails.
- The air compressor governor stops the compressor from pumping air (cut-out) at about:Answer: 125 psiThe governor stops the compressor at about 125 psi and restarts it (cut-in) at about 100 psi.
- The air compressor should start pumping again (cut-in) at about:Answer: 100 psiCut-in is around 100 psi; cut-out is around 125 psi.
- The low air pressure warning must come on before tank pressure falls below:Answer: 60 psiA warning light or buzzer must activate before air pressure drops below 60 psi.
- In most vehicles, the spring brakes come on automatically when air pressure drops to between:Answer: 20 and 45 psiSpring brakes apply on their own when pressure falls into the 20 to 45 psi range.
- The air tank safety relief valve is usually set to open at about:Answer: 150 psiThe safety valve protects the system from too much pressure, usually opening at 150 psi.
- Air tanks should be drained to remove:Answer: Water and compressor oilWater and oil collect in the tanks and can freeze or damage brakes.
- An alcohol evaporator is used in some air brake systems to:Answer: Reduce the risk of ice in air valves in cold weatherAlcohol added to the air lowers the chance of moisture freezing in the system.
- With the engine at fast idle, a dual air system should build pressure from 85 to 100 psi within:Answer: 45 secondsIf pressure builds too slowly, the system may have a problem.
- With the engine off and brakes released, air loss in a single vehicle should be no more than:Answer: 2 psi in one minuteStatic leakage limits: 2 psi per minute for single vehicles, 3 psi per minute for combinations.
- With the engine off and the service brakes fully applied, a combination vehicle should lose no more than:Answer: 4 psi in one minuteApplied leakage limits: 3 psi per minute for single vehicles, 4 psi per minute for combinations.
- When you can pull a brake pushrod more than about 1 inch by hand where it attaches to the slack adjuster, the brake:Answer: Probably needs adjustmentExcess slack means the brake is out of adjustment and will not stop the vehicle well.
- 'Brake lag' in an air brake system is:Answer: The time it takes air to flow to the brakes after you press the pedalBrake lag adds distance to your stop, so air-braked vehicles need more stopping distance.
- Total stopping distance for an air-braked vehicle is made up of perception distance, reaction distance, braking distance and:Answer: Brake lag distanceAir brakes add brake lag distance to the usual stopping distance.
- On a long downgrade with a 40 mph safe speed, you should use 'snub braking' by:Answer: Braking until you are about 5 mph below the safe speed, then releasingApply the brakes firmly enough to slow to about 35 mph, then release. Repeat when you reach 40 mph again.
- If the low air pressure warning comes on while driving, you should:Answer: Stop safely as soon as possibleLow pressure can lead to spring brakes locking. Stop and park safely while you still have control.
- You should not use the parking brakes when:Answer: The brakes are very hot or wet in freezing weatherHot brakes can be damaged and wet brakes can freeze. Use wheel chocks instead.
- To test the service brakes before driving, you should:Answer: Move forward slowly (about 5 mph) and apply the brakes firmlyA firm stop at low speed shows whether the vehicle pulls to one side or stops poorly.
- An air brake 'wig wag' is a:Answer: Low-pressure warning device that drops into viewA wig wag is a mechanical arm that drops into the driver's view when air pressure is low.
- Truck tractors with air brakes built on or after March 1, 1997 are required to have:Answer: Anti-lock brakes (ABS)Federal rules require ABS on air-braked tractors built on or after March 1, 1997.
- With anti-lock brakes, you should brake:Answer: The same way you normally would, with steady pressureABS keeps wheels from locking. Brake normally and keep steering.
- The supply pressure gauge shows:Answer: How much pressure is in the air tanksThe supply pressure gauge shows the air pressure available in the tanks.
- The application pressure gauge shows:Answer: How much air pressure you are applying to the brakesIf you need more and more pressure to hold speed, your brakes may be fading.
- The air compressor is driven by:Answer: The engine, through gears or a beltThe compressor runs off the engine via gears or a V-belt.
- Why should you drain the air tanks completely?Answer: Water and oil left in the tanks can cause brake failureMoisture and oil can damage the system and freeze in cold weather.